SERVICE

The knowledge about woodworking machine'smaintenance in winter


SEAZEA MACHINERY CO., LTD

一、Clean up 

1, the work should be cleaned in time table,
2, clean the guide rail and the side of the material,
3, regular cleaning of the screw, to prevent the screw on the sticky foreign body, the screw is very important in the equipment
4, regular cleaning industrial control box, dust is the biggest killer circuit board.
二、Oiling 
1, clean the guide rail and the lead screw, can be used cloth (not hair removal) on the guide rail and lead screw on the oil and material to clean up.
2, the gas cycle for adding oil every two weeks.
3, if the machine does not use for a long time, it should be regular refueling empty to ensure the flexibility of the transmission system.
4, after the oil slowly back and forth to ensure that the lubricant can be uniformly added to the guide rail and screw.
三、temperature
1, to ensure the operation of the environment temperature, the best room temperature, at least the staff will not be very cold.
2, check the oil standard applicable temperature, at least the minimum temperature.
3, the machine when not in use, if the temperature is lower better pour out the water in the water tank, the water tank and the water pipe to prevent the cracking
四、cooling water   cooling water is the necessary condition for the normal operation of the spindle motor, if the cooling water dirty will cause serious damage to the motor, to ensure the cleanliness of the cooling water and the normal operation of the pump

Copyright © All rights reserved SEAZEA Designed by Sinmic Inc (USA) Assembled in SEAZEA